Clutch or Transmission problems

[rac3r]

Adding to the list so far. This time the bike now starts perfectly but when you put it in first it jerks forward and the engine cuts out then the bike will not even start when you hold in the clutch. It now does not even find neutral! Can someone please help me because it's my first bike which i haven't even ridden yet!

(2000 RS125)
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636

[rac3r]

...Someone help please!!!
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636

[MaybeGuy]

is your sidestand down?

if not, check your sidestand cutout switch.

bike gearboxes dont like being used when the bike isnt moving, so try rocking the bike back and forth when searching for neutral.
____________________
Blue_SV650S wrote: it was a sh1te wheelie, but it proves that he can get it up in 3rd and can do angles. In summery, mattsprattuk is a gobby little sh1tebag, dopehead tw4t, but sadly for all of us, he probably isn't THAT full of sh1te!!
Kickstart wrote: Hi I tend to agree with Matt. All the best Keith

[Cigaro]

When you say it won't start with the clutch in after putting it in gear - does it not turn over at all? Or turn over slowly?

[rac3r]

You can only hear the starter motor when you try and hold the clutch in and start it. The sidestand cut off switch has been cut by the previous owner. The gear lever is now also very stiff.
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636

[MaybeGuy]

[rac3r]

i rocked it back and forward and found the rest of my gears but still no neutral. there are three wires and 2 are joined together. could it have anything to do with the oil
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636

[ratboy]

is the clutch cable intact? sounds like its either loose or snapped. follow the cable to the engine and see if it pulls the lever.
fairly cheap to buy and easy to replace.
if not your side stand switch probably needs replacing.
with it being your first bike and all you may leave it down once in a while, and the switch can save you from finding out round a corner as it throws you off!
its also a cheap part and can be fitted fairly easily.
hope this helps

tom

[rac3r]

The side stand flips up as soon as you lift the bike so that shouldn't be a problem. Thanks for the info anyways i'll try it all out tomorrow. I'm sooo close to selling this bike!
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636

[rac3r]

How do you take the clutch cable off?
____________________
Bikes : 2006 CBR125R - 2004 Monster 620ie - 2004 ZX-6R B1H - 2005 Monster S2R 800 - 2011 Street Triple - 2009 Streetfighter 1098 - 2014 ZX-6R 636