Getting the front wheel off...

[s44678]

When you don't have a front paddock stand?

Any ingenious ideas?

[SlimRick]

Centre stand and loads of weight on the back?

[SlimRick]

Or trolley jack underneath the engine?

[binge]

What sort of bike is it to start with?


There are a couple of methods. Do you have a trolley Jack?

Side stand down. Lean the bike onto the side stand. Slide a trolley jack under the front of the exhaust headers. Take up the gap with the jack, Then guide the bike up onto the back wheel and side stand, while using the jack as a 3rd support under the exhaust headers.





Ben

[SlimRick]

Or hoist from your garage roof rafters?

[Tristan.]

Got a car jack? that makes things a lot easier.

Fairing lowers off then a plank under the sump/downpipes supported one end by bricks and the other by the jack (put something solid under that end too when it's in the air, jacks can leak oil and go down.)

or hoist it up through the headstock if you have a garage with beams

[Mudskipper]

https://img.photobucket.com/albums/v246/super_jo/gix15sep082019.jpg

https://img.photobucket.com/albums/v246/super_jo/frontendoff.jpg

Tilt bike so weight is on side stand (easier with two people but not impossible on ya own), slide block under frame on opposite side. Tilt slightly onto block side, slide lower block under sidestand.

Obviously axle stands are better, but if you have to use what you've got...
____________________
CBR125|||GSXR400|||CBR400|||CBR400|||CB250RS|||GSXR750|||CB250RS
"You're clumsy, you eat too much and you behave like a 12 year old boy. But you know what? Every once in a while, you find a thumb."

[s44678]

[chris-red]

I go with the tarts way, I bought the abba stand and front lift, best £140 I ever spent. I got my Speed Four fitting kit today and thought I will take it to the garage got there and though ah fuck it I may as well get the bike up. It took me 2 minutes on my own wearing a dressing gown with a rotten cold to get both wheels off the ground.

Top quality bit of kit.
____________________
Well, you know what they say. If you want to save the world, you have to push a few old ladies down the stairs.
Skudd:- Perhaps she just thinks you are a window licker and is being nice just in case she becomes another Jill Dando.
WANTED:- Fujinon (Fuji) M42 (Screw on) lenses, let me know if you have anything.

[Bikeless]

Loosen any tight bolts first, .

[s44678]

[stinkwheel]

You can push the front end over towards the side stand so the wheel lifts off the ground then put a chock of wood/axle stand under the engine at the front to hold it there.

It is no less stable than leaving it on the sidestand normally.

This leaves the bike balanced on the rear wheel, sidestand and bit of wood. Works fine. You can do this for the rear wheel too by putting your stand under the swingarm. In fact, you can do both at once.

As has been said, do the preliminary stripping (callipers off etc) and loosen the main nut before you lift it.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.