to fix it or to scrap it

[Welshd1k]

well the ns is in a poor state after almost 16 thousand miles in my hands .

she is a ratty bike but served me well. prior to the engine incident she was a 2 kick gogogog bike, so see what happens otherwise there will be a ns 125 on ebay with 11 months tax and mot


damage assesment

keep in mind this bike has done 16 thousand miles since i rebuilt it
she looks like this just sooo much dirtier now

https://i26.tinypic.com/2helm48.jpg
not bad for a old bike hauling my 14 stone arse around @ 70-80 allday and an indicated 100 head on tank hahaha

my piston actualy melted kinda....

hoping i can get my mate to hone it out as all the damage is EXTRA to the barel there is no indentation its all melted piston stuck to the barrel.

https://i46.tinypic.com/ip19jn.jpg
https://i50.tinypic.com/19awxd.jpg
https://i48.tinypic.com/16jpl54.jpg
https://i45.tinypic.com/55fc03.jpg
https://i46.tinypic.com/24qvbyp.jpg
https://i49.tinypic.com/2507cw8.jpg

https://i49.tinypic.com/281aba0.jpg



so what you all think ? try fix it or just get rid of it
____________________
Current >Cb600fx hornet, ns125rk90 21.7bhp@wheel<
Sold >,zxr400 h2 (33bhp kit) rd350 n1 rd350 lc2<

[BenR]

Fix it, you're not going to get much for it non running. There was one on ebay a few weeks back in fair condition but a non runner think it went for £86.
____________________
Current bikes: suzuki RG125UN wolf. Yamaha MT-07

[Welshd1k]

[Billing]

[Welshd1k]

tbh it would have done 20-25k on the piston that was in it , when i rebuilt it it had a brand new crank + original honda piston and a breand new barrel . i rechon it woulda don 25k without a doubt
____________________
Current >Cb600fx hornet, ns125rk90 21.7bhp@wheel<
Sold >,zxr400 h2 (33bhp kit) rd350 n1 rd350 lc2<

[Shreddie]

Fix it dude.

[hmmmnz]

for how easy it is to fix, i wouldnt even have bothered to ask on the forum,
it sounds like she has served you well to boot,
show her some love
____________________
the humans are dead
I kick arse for the lord
Wiring Diagrams BIDNIP it bitches

[webbaldo]

fix then flog, like the guy said if it aint running youll get nowt.

[Mystery]

can't you just bore it out or get it skimmed in the inside with new piston and barrel?
____________________
Carbon knuckles assure you maximum protect against debris and unfortunate accidents or if someone cuts you off, their side mirror.Mopeds are like chubby chicks.. they are really fun to ride until you're friends catch you on one

[ms51ves3]

[smegballs]

[27cows]

I'd clean up the bore and see what it looks like. If it's OK, bang a new piston in it. If it's not, get another barrel from somewhere. Plenty of life left in that old girl yet

[Mystery]

[tutton]

With a oldish bike thatll propably pop it again soon, insted of nikasiling id just get a liner stuck in it, can keep reboring then
____________________
Past: '05 Peugeot XPS '99 Aprillia RS125 '94 FZR600R
Current: '02 ZX636 A1P '51 CCM R30

[chillpill]

it ran dry of oil check if the cranks okay before thinking about the topend , otherwise just get a cheap engine and whack it in there

[Welshd1k]

[ms51ves3]

[maddaz]

i had one of these, neva gave me any probs, i had full fairings sprayed camel racing, allspeed exhaust, braided hoses, total engine rebuild and tune up was doin over 100 mph, sold it wish ad kept it