zx6r spark plugs

[brett750]

hi.
i have a thread in show and tell, and was just wondering if i will have to remove my carbs to change the spark plugs on a zx6r j1?

i also plan to remove the restrictors from the carb manifolds. could i do this by loosening or will they need removing?

thanks

[lonie]

you will porobably have to take the tank off or lift it to get at the carbs and plugs as for the restrictor youll need to takt them off

[brett750]

iv already got the tank off, and the air box will be comeing off tomorrow.
is it a hard job to take the carbs off because im not known for my mechanical abilities. will they need setting back up?

thanks

[lonie]

remove throtle cables unbolt maifold drain floats disconect varios pipes and you don not hard 30min job to take em off and strip them

[evoboy]

To get at the plugs on my J1 2000 model zx6, you onto need to remove the airbox, but its still an arse of a job to do.

To take out the restrictors, you take the airbox off, loosen the clamps on the bottom of the carbs (3mm allen key i think), then pop the carbs off and move them back a bit...

You shouldnt even need to take off any pipes or cables.
____________________
Suzuki GT250 x7------- Fazer 600------CB250RS------Aprilia Rally 70----- Bandit 600

APT Motorcycles

[brett750]

well i hope your right mate. ill let you know tomorrow or sunday. cheers

[brett750]

managed to do the spark plugs today. the one on the left (clutch) side was a bugger to get out but its all good now. will be having a crack at taking the restrictrs outa the carbs tmorro. wish me luck.....

[temeluchus]

with the airbox off, you can probably just loosen the clamps on the carbs, lift them onto the head and pull the restrictors out of the inlet rubbers. I doubt youll need to disconnect the throttle cables.
____________________
Some shite cruiser. Now with guns and FREEDOM!