NSR electrics help!!!

[Bunter]

ok was doing some work on nsr and had the air filter and all out. Put all back together and turned the key and there was nothin, no sounds lights or anything. Checked the main fuses and they looked ok.

Any other ideas???

[c058y]

I recently had this problem! It turned out to be corroded wires within the loom!

I put a post on here regarding this, have a look at it and it should help you!

Good luck

https://www.bikechatforums.com/viewtopic.php?t=29643

[Bunter]

so am i just gonna have to wiggle everything until it lights up or sumthin???

[c058y]

tried that myself, but it just didnt work. You can give it a go but the thing is if you manage to fix it temporarily, when will it stop working again? While your riding the thing? I know I wouldnt want to risk it.

Good luck if you try and locate the corroded wires within the loom. Just remember after checking a section replace the wires where they came from otherwise the mechanic that you hand the bike over to will hate you for it, plus it will cost you even more to repair!

[alains]

first , check the battery voltage (sould be 12.8 to 13.2 Vots) and if it's less than that , put it in slowly charge for 6 hours (max 2Amps)
secondl , check the fuse (take it off , check with ohmmeter) , if OK then clean the contacts (even on the support)and replace it
third , check your ground connection wiring , it's a green big wire going from the battery to the starter (may be broken somewhere)
____________________
the worst day fishing is better than the best day working