Fitting Hand Guards

[bridgedino]

Hi,

Started to fit my hand guards today, only when I trimmed off the end of the throttle grip to insert the bar-end I found it wasn't a hollow hole.

Instead I found what I assume is the plastic throttle housing body which rotates.

So does anyone know if it is possible drill to open up the end of it and slip the bar-end in?

Or is it likely to turn not a can of worms?

Thanks

[bladerunner]

Would think its just the end of your throttle tube. Why not undo the switch gear and take a proper look!
____________________
Current bikes...cbr929, KDX200's, Rd125lc mk2, RGV250's

[bridgedino]

Thanks. Yeah it's the throttle tube I'm sure but im un sure if it can be opened up at the end or not.

Therefor how do you think i can I go about fitting my guards?

[G]

As above - pretty sure it's just the end of the throttle tube.

Get the throttle tube off completely anyway to be sure and to make sure what's behind it is ok.

[bladerunner]

If your fitting guards then you don't need the end of the tube, so either drill it or cut it off.
____________________
Current bikes...cbr929, KDX200's, Rd125lc mk2, RGV250's

[bridgedino]

Thanks guys, job done before it got dark. Trimmed of end of tube with trusty junior hacksaw.

Cheers

[bladerunner]

PICS !!!
____________________
Current bikes...cbr929, KDX200's, Rd125lc mk2, RGV250's

[bridgedino]

Lol I will do, once it gets light again