Resend my activation email : Register : Log in 
BCF: Bike Chat Forums


All electrics cuts out

Reply to topic
Bike Chat Forums Index -> The Workshop
View previous topic : View next topic  
Author Message

DynamiteBoy
Scooby Slapper



Joined: 09 Oct 2005
Karma :

PostPosted: 17:27 - 17 Mar 2014    Post subject: All electrics cuts out Reply with quote

Hi All,

I am currently experiencing an odd electrical problem with my Kawasaki ER6 2007 that I can not resolve.

Issue: The bike will start and run from around a few seconds to 2 minutes. At a certain point ALL the electrics will cut out, no light, display... nothing. Its like the battery has been disconnected. The battery still has power as my heated grips will work. Turning the key in the ignition then becomes temperamental. Sometimes the everything will re-work and display, FI etc all come on. Most of the time I have to keep turning the key until all the power returns. Upon re-starting I am back to square one, will run for short period (feels shorter) and will then suddenly cut-out.

I have check battery volt reading with multimeter when off and also running, all looks fine. I have checked all fuses including the main fuel and inspected wires under tank and seat. So far no luck and it is driving me nuts.

Does anybody have any suggestions or come across anything similar in past? Don't want to go spending lots of money replacing parts in hope of resolving.
____________________
"I dont like my Job anymore - I dont think i'll go" OfficeSpace

Honda CG125 (sold) - Kawasaki GPZ500s (sold) - Kawasaki Zephyr 550 (sold) - Kawasaki er6n (current work horse)
 Back to top
View user's profile Send private message You must be logged in to rate posts

331X2
Crazy Courier



Joined: 10 Jul 2013
Karma :

PostPosted: 17:30 - 17 Mar 2014    Post subject: Reply with quote

Sounds like a dodgy ignition switch. Measure the resistance across it when both open and closed, open should measure infinite (or out of range) and closed (ignition on) should measure very little i.e. 0.1 Ohms.

I take it your heated grips are not fed from the ignition live?

Edit: If it is a high resistance contact on the ignition switch this will cause heat build up on the contact leading to higher resistance leading to higher heat leading to... You see where I'm going with this?
 Back to top
View user's profile Send private message You must be logged in to rate posts

J.M.
World Chat Champion



Joined: 27 Mar 2011
Karma :

PostPosted: 17:37 - 17 Mar 2014    Post subject: Reply with quote

You checked the fuses, but did you check their condition? A corroded surface can lead to an intermittent connection.

I'd also be checking the connections of the ignition barrel plug, and generally tracing the 12v right from the start of the battery, and keep probing it along the wire until I find the point at which the 12v is lost.
____________________
2004 R1 & 2018 XSR900
 Back to top
View user's profile Send private message You must be logged in to rate posts

DynamiteBoy
Scooby Slapper



Joined: 09 Oct 2005
Karma :

PostPosted: 17:40 - 17 Mar 2014    Post subject: Reply with quote

My heated grips are connected direct to battery so do not need the ignition on to work.

Thanks for the suggestion, ill try this. Anyone else have any ideas or where to look? Planning on making a day testing.
____________________
"I dont like my Job anymore - I dont think i'll go" OfficeSpace

Honda CG125 (sold) - Kawasaki GPZ500s (sold) - Kawasaki Zephyr 550 (sold) - Kawasaki er6n (current work horse)
 Back to top
View user's profile Send private message You must be logged in to rate posts

P.addy
Red Rocket



Joined: 14 Feb 2008
Karma :

PostPosted: 17:44 - 17 Mar 2014    Post subject: Reply with quote

fatjames had an issue on here (sure it was him) that ended up being a relay.

Scrap that, was a relay for headlight, might be similar though - https://www.bikechatforums.com/viewtopic.php?p=3794950


Last edited by P.addy on 17:45 - 17 Mar 2014; edited 1 time in total
 Back to top
View user's profile Send private message Send e-mail You must be logged in to rate posts

Copycat73
World Chat Champion



Joined: 11 Jan 2013
Karma :

PostPosted: 17:44 - 17 Mar 2014    Post subject: Re: All electrics cuts out Reply with quote

DynamiteBoy wrote:

Does anybody have any suggestions or come across anything similar in past?


yep .. was the ignition contacts at the bottom of the barrel was corroded & full of crap... strip & clean to fix.
____________________
Whatever I post I have no citation and no intention of providing one..
caveat emptor
 Back to top
View user's profile Send private message You must be logged in to rate posts

Dischord
World Chat Champion



Joined: 08 May 2005
Karma :

PostPosted: 19:08 - 17 Mar 2014    Post subject: Reply with quote

Check all earths are good?
____________________
2012 KTM EXC 250

Check out my vids - https://www.youtube.com/user/KTMSparky/videos
 Back to top
View user's profile Send private message You must be logged in to rate posts

DynamiteBoy
Scooby Slapper



Joined: 09 Oct 2005
Karma :

PostPosted: 11:07 - 23 Apr 2014    Post subject: Reply with quote

Fixed: Quick update if anyone has same problem in the future.

Turned out 2 wires on the loom were corroded and needed replacing along with the starter relay. Since these have been changed the bike is running fine.

Thanks for all the suggestions.
____________________
"I dont like my Job anymore - I dont think i'll go" OfficeSpace

Honda CG125 (sold) - Kawasaki GPZ500s (sold) - Kawasaki Zephyr 550 (sold) - Kawasaki er6n (current work horse)
 Back to top
View user's profile Send private message You must be logged in to rate posts
Old Thread Alert!

The last post was made 12 years, 211 days ago. Instead of replying here, would creating a new thread be more useful?
  Display posts from previous:   
This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. By clicking on an affiliate link, you accept that third-party cookies will be set.

Post new topic   Reply to topic    Bike Chat Forums Index -> The Workshop All times are GMT
Page 1 of 1

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

Read the Terms of Use! - Powered by phpBB © phpBB Group
 

Debug Mode: ON - Server: biskey (www) - Page Generation Time: 0.08 Sec - Server Load: 0.5 - MySQL Queries: 13 - Page Size: 55.61 Kb