|
Author |
Message |
Bob Pattinson |
This post is not being displayed .
|
 Bob Pattinson L Plate Warrior
Joined: 23 Nov 2014 Karma :  
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
Islander |
This post is not being displayed .
|
 Islander World Chat Champion

Joined: 05 Aug 2012 Karma :    
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
Bob Pattinson |
This post is not being displayed .
|
 Bob Pattinson L Plate Warrior
Joined: 23 Nov 2014 Karma :  
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
robocog |
This post is not being displayed .
|
 robocog Traffic Copper
Joined: 17 Apr 2009 Karma :   
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
Nemo |
This post is not being displayed .
|
 Nemo Could Be A Chat Bot

Joined: 30 Apr 2010 Karma :  
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
P. |
This post is not being displayed .
|
 P. Red Rocket
Joined: 14 Feb 2008 Karma :   
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
Islander |
This post is not being displayed .
|
 Islander World Chat Champion

Joined: 05 Aug 2012 Karma :    
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
WD Forte |
This post is not being displayed .
|
 WD Forte World Chat Champion

Joined: 17 Jun 2010 Karma :   
|
 Posted: 15:40 - 24 Nov 2014 Post subject: |
 |
|
Never heard of a Henson so googled it
I did find a 'Hensim' 110cc ATV
this one?
https://www.extrememotorsales.com/Hensim_Utility_110cc_Kids_ATV.htm
Assuming the new stuff is AOK
I'd start by disconnecting the kill switch wire from the cdi and test the pulser coils ____________________ bikers smell of wee |
|
Back to top |
|
You must be logged in to rate posts |
|
 |
_Iain_ |
This post is not being displayed because the poster is banned. Unhide this post / all posts.
|
 _Iain_ Banned

Joined: 01 Feb 2012 Karma :     
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
WD Forte |
This post is not being displayed .
|
 WD Forte World Chat Champion

Joined: 17 Jun 2010 Karma :   
|
 Posted: 15:50 - 24 Nov 2014 Post subject: |
 |
|
Found this for a Hensim 150cc and assuming they don't vary much
in wiring
would disconnect the black/white in case the kill switch is shorting to ground
and then measure the resistance between both the
black/red then blue/white to ground.
I'll guess at circa 300 ohms? as its an AC CDI
If its say 2 ohms or Megaohms then it may be knackered
followed by an AC voltage check when the engine is being cranked
again guess at say 100VAC?
EDIT:
Just noticed the diagram, has test resistances and voltages
at the top so there ya go !
https://i397.photobucket.com/albums/pp60/LynnEdwards_photo/QuadSchematic1.jpg ____________________ bikers smell of wee
Last edited by WD Forte on 16:04 - 24 Nov 2014; edited 3 times in total |
|
Back to top |
|
You must be logged in to rate posts |
|
 |
WD Forte |
This post is not being displayed .
|
 WD Forte World Chat Champion

Joined: 17 Jun 2010 Karma :   
|
|
Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 10 years, 213 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|