Installing Oxford heated grip on a Street Triple

[stuey2407]

I started to install some Oxford Heated grips on my Street Triple today. There was no problem removing the existing grips and although I removed all the ridges on the throttle tube the grip is still quite tight to get on.

I will probably try to get the grip on with an inch or so left and then apply the super glue to the exposed part of the throttle tube and inside the grip before twisting it fully home. Is there anythings I could use to help slide the grip on which won't interfere with the adhesion of the glue?

The other question I had was the routing of the wire. There isn't much room where existing wiring enters the frame so I am planning on routing it in under from the tank through the space at the front to one side of the bolts. Any thoughts?

[b422063]

If you need time before it setting (superglue gives you about a minute before curing) then try epoxy?

Alternatively, ensure the grips are on full before putting them on. You'll find they expand slightly and slide on easier.

[stuey2407]

I think I have some araldite somewhere. Would that be suitable?

[raesewell]

Hair spray is recommended by many people
____________________
Yamaha FJR 1300 Normanton West Yorkshire

[stuey2407]

[blackbosh]

The oxford glue eventually gave on the left side on my triple, with regards to your throttle side i kept smoothing the ridges until it went on with the same amount of force as the left side. The wires will easily follow the stock cables through the frame as well making for a neat install

[b422063]

[barrkel]

[c_dug]

I've not managed to properly stick mine in place at all yet using superglue, they still slide a small amount on the twist grip if I whack the throttle open, and I used a really decent amount last time.

To be fair I'm happy enough with the small amount of movement in exchange for the ability to remove them if/when I want to.

Had mine for about 18 months now and still going strong with regular use.
____________________
I am a bellend, I am a man of constant sorrow, I am a gummy bear, I am a rock.

[el_oso]

I never glued mine, don't even think I used hairspray. They were just a really snug fit. Get a slight bit of movement but I'm OK with that, I can at least get them off if I need to.
____________________
Duke 390
Previous: '05 XR125L | '96 XJ600S Diversion |'05 Suzuki GSXR1000 | '05 Honda CBR125-R | '97 YZF 600R Thundercat | '11 Honda CBR250
Car: Jeep Wrangler 4.0L