Resend my activation email : Register : Log in 
BCF: Bike Chat Forums


Heated grips getting power but not heating

Reply to topic
Bike Chat Forums Index -> The Workshop
View previous topic : View next topic  
Author Message

TonyD
Derestricted Danger



Joined: 29 May 2014
Karma :

PostPosted: 12:09 - 13 Jan 2015    Post subject: Heated grips getting power but not heating Reply with quote

When I bought my K6 Bandit last year the original owner had installed Oxford Heated Grips and they worked like a dream until recently. However now they're just not getting hot at all on either side.

The unit is getting power - the LEDs light up and I've tested each connection for voltage from the battery - but the grips simply don't get warm. Any ideas what might be up with it?

https://i1236.photobucket.com/albums/ff448/MrTonymeister/IMG_3296_zps887b8983.jpg
____________________
Suzuki Marauder 125 (sold) --> Suzuki Bandit GSF650SA (for sale!) --> Triumph Daytona 600
 Back to top
View user's profile Send private message You must be logged in to rate posts

Confusion
Scooby Slapper



Joined: 02 May 2013
Karma :

PostPosted: 12:37 - 13 Jan 2015    Post subject: Re: Heated grips getting power but not heating Reply with quote

TonyDraper wrote:
Any ideas what might be up with it?


The control unit of the Oxford grips is prone to failure.

Check all wiring. Check the resistance of the two grips. I don't know
the exact resistance value for this model, but most heated grips take
about two amps for each side, so the resistance should be approximately
6 ohms. Also check the battery voltage while the engine is running.
Some Oxford heated grips will shut off automatically if the supply voltage
is below ~13V.

If the supply voltage, wiring and grips are all ok, the problem
must be in the controller.
____________________
Bandit 650SA, ZZ-R1100
 Back to top
View user's profile Send private message You must be logged in to rate posts

TonyD
Derestricted Danger



Joined: 29 May 2014
Karma :

PostPosted: 23:41 - 14 Jan 2015    Post subject: Reply with quote

Thanks for the reply. The battery is brand new a couple of days ago and fully charged so I know that's absolutely good. I'll measure the resistance on the grips but I know the voltage is getting to each of the connectors from the battery so it's not a power supply issue. The unit is designed to flash if the voltage across the battery is low so I know that's not the problem.

Anything else it could be or is it looking highly likely that the control unit has simply failed?
____________________
Suzuki Marauder 125 (sold) --> Suzuki Bandit GSF650SA (for sale!) --> Triumph Daytona 600
 Back to top
View user's profile Send private message You must be logged in to rate posts

c_dug
Super Spammer



Joined: 04 Sep 2007
Karma :

PostPosted: 07:00 - 15 Jan 2015    Post subject: Reply with quote

Short of broken wires there isn't much that will make the grips themselves give up, there isn't much there to go wrong. If both have given up at the same time I would also guess at the control unit being at fault.
____________________
I am a bellend, I am a man of constant sorrow, I am a gummy bear, I am a rock.
 Back to top
View user's profile Send private message Send e-mail You must be logged in to rate posts

Matt B
World Chat Champion



Joined: 01 May 2012
Karma :

PostPosted: 10:35 - 15 Jan 2015    Post subject: Reply with quote

Another vote for the controller.

Oxford control units are under £30 on ebay.
____________________
stinkwheel: He had an animated .gif of a cat performing fellatio. It's not socially acceptable. It can have real life adverse effects on other people.
 Back to top
View user's profile Send private message You must be logged in to rate posts

Taught2BCauti...
World Chat Champion



Joined: 12 Jan 2012
Karma :

PostPosted: 10:45 - 15 Jan 2015    Post subject: Reply with quote

If you are sure that you have voltage at the grips, disconnect them from the controller and check the resistance with an ohm-meter on a low range.

You should see something between 5 and 10 ohms, otherwise the heating element has either burned out, or become disconnected from the wiring.
____________________
Honda Varadero XL125(V8)
www.TheFutureIsHere.eu
 Back to top
View user's profile Send private message Send e-mail You must be logged in to rate posts

TonyD
Derestricted Danger



Joined: 29 May 2014
Karma :

PostPosted: 22:29 - 17 Jan 2015    Post subject: Reply with quote

Thanks all. Since they were relatively old the unit is long discontinued so I've plumped that the newer version of the HotGrips will be the same. The connectors are exactly the same so hopefully the control unit will replace the one I have and all will be hunky-dory. Thanks for your responses.
____________________
Suzuki Marauder 125 (sold) --> Suzuki Bandit GSF650SA (for sale!) --> Triumph Daytona 600
 Back to top
View user's profile Send private message You must be logged in to rate posts
Old Thread Alert!

The last post was made 11 years, 256 days ago. Instead of replying here, would creating a new thread be more useful?
  Display posts from previous:   
This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. By clicking on an affiliate link, you accept that third-party cookies will be set.

Post new topic   Reply to topic    Bike Chat Forums Index -> The Workshop All times are GMT + 1 Hour
Page 1 of 1

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

Read the Terms of Use! - Powered by phpBB © phpBB Group
 

Debug Mode: ON - Server: birks (www) - Page Generation Time: 0.07 Sec - Server Load: 1.35 - MySQL Queries: 13 - Page Size: 52.75 Kb