Fitted hot grips - now throttle sticks

[Andy_Pagin]

What happens is the throttle doesn't snap shut when I release it so I'm guessing some of the glue has run into the throttle body or between the bar and throttle sleeve. How easy is to dismantle the throttle unit? Do I just unbolt it or do the throttle cables need releasing from the carbs first. Bike is 2003 Fazer.
____________________
They're coming to take me away, ho-ho, hee-hee, ha-haaa, hey-hey,
the men in white coats are coming to take me away.
Yamaha Vity -> YBR125 -> FZS600 Fazer -> FZ1-S Fazer

[Nobby the Bastard]

Take off the bar weight and see if it still does it
____________________
trevor saxe-coburg-gotha:"Remember this simple rule - scooters are for men who like to feel the breeze on their huge, flapping cunt lips."
Triumph Sprint ST 1050

[Courier265]

[P.]

It's always going to be rubbing on the bar end or the plastic handlebar controls. Can trim the ends of the heated grips gently so only the rubber bits.

Is why muffs are supreme btw.

[Nobby the Bastard]

My FZ developed a sticky throttle after I'd been riding for about 10 miles each time I rode it.

It took me about 6 months to work out it was the heated grip expanding enough when hot it was rubbing on the bar end weight....
____________________
trevor saxe-coburg-gotha:"Remember this simple rule - scooters are for men who like to feel the breeze on their huge, flapping cunt lips."
Triumph Sprint ST 1050

[Andy_Pagin]

Sorted. Turned out to be a tiny smear of glue between the bar and throttle sleeve. Dismantling the twist grip was dead easy.
____________________
They're coming to take me away, ho-ho, hee-hee, ha-haaa, hey-hey,
the men in white coats are coming to take me away.
Yamaha Vity -> YBR125 -> FZS600 Fazer -> FZ1-S Fazer