leaking clutch slave???

[Streaky100]

I changed the clutch fluid in the reservoir on my GPZ1100 and bled it until the biting point was about half way through the lever travel. after a day of riding, the biting point is right by the handle bar. I can't see anything obviously leaking, so could it be the seal inside the clutch slave cylinder and the fluid is just building up inside the engine case?

[stinkwheel]

The only way to answer that question would be to have a look.

I do wonder if you've fully bled it though, you should be getting pressure from the very top of the lever action. If there is air left in the system, it'll be decidedly odd and will do odd things. Bleed it until no air comes out.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.

[Riejufixing]

[-]

They're very east to remove and check. I've had 2 slave seals go on my on two bikes. Usually though, on my EXUP type Yamaha's you can see it weeping from the bottom of the slave cylinder, down the side of the crankcase/front sprocket cover when the seal has gone.
____________________
TZR250 2MA road, TZR250 1KT road, TZR250 2MA race, TDR250, YZF-750R Boost colours.
Jaguar S Type 3.0 V6 Sport R, VW Transporter T5 GP LWB Shuttle 140ps DSG.

[Streaky100]

Sorted it...I think the seal had maybe dried out letting in air. Replaced the seal and sorted it out 😀😀😀