Resend my activation email : Register : Log in 
BCF: Bike Chat Forums


Troubleshooting

Reply to topic
Bike Chat Forums Index -> The Workshop
View previous topic : View next topic  
Author Message

Darylw27
Nova Slayer



Joined: 19 May 2011
Karma :

PostPosted: 14:44 - 26 Feb 2014    Post subject: Troubleshooting Reply with quote

In the past few hours a new problem has just developed with my bike (2011 ER6n) after overtaking a parked vehicle with a quick blast of acceleration something just went where the sound of the bike suddenly became much more deep and throaty as well as quiet. On the way home it was an absolute fight to get to 70mph on the motorway in 6th gear with the throttle open 100%.

To sum it up, bike feels like a 125. Spluttering and nearly stalling at 15mph in 1st gear. Bike also idles about 2-400rpm less. Could it be a cylinder is away/spark plug?
 Back to top
View user's profile Send private message You must be logged in to rate posts

SQL
World Chat Champion



Joined: 08 Aug 2012
Karma :

PostPosted: 14:47 - 26 Feb 2014    Post subject: Reply with quote

Might have dropped a cylinder, check the spark plug in both pots
 Back to top
View user's profile Send private message Visit poster's website You must be logged in to rate posts

sickpup
Old Timer



Joined: 21 Apr 2004
Karma :

PostPosted: 20:23 - 26 Feb 2014    Post subject: Reply with quote

SQL wrote:
Might have dropped a cylinder, check the spark plug in both pots


More likely the exhaust has snapped just in front of the silencer.
 Back to top
View user's profile Send private message You must be logged in to rate posts

SQL
World Chat Champion



Joined: 08 Aug 2012
Karma :

PostPosted: 20:51 - 26 Feb 2014    Post subject: Reply with quote

Ah possibly would explain the change in noise didn't think that would reduce power to that extent to be honest.
 Back to top
View user's profile Send private message Visit poster's website You must be logged in to rate posts

Darylw27
Nova Slayer



Joined: 19 May 2011
Karma :

PostPosted: 22:35 - 26 Feb 2014    Post subject: Reply with quote

That's what I though and first checked sickpup that the exhaust had maybe blown, but looks to be in perfect condition, the sound and feel certainly suggests only one cylinder is firing. Getting new plugs on Friday to give them a try. Other than that I'm out of ideas!
 Back to top
View user's profile Send private message You must be logged in to rate posts

sickpup
Old Timer



Joined: 21 Apr 2004
Karma :

PostPosted: 22:46 - 26 Feb 2014    Post subject: Reply with quote

How did you check?
 Back to top
View user's profile Send private message You must be logged in to rate posts

Darylw27
Nova Slayer



Joined: 19 May 2011
Karma :

PostPosted: 00:16 - 28 Feb 2014    Post subject: Reply with quote

To check the exhaust I shoved a rag in the silencer, no sound of any air blowing. Had also run my hand around the length of the exhaust from the silencer up to the headers and nothing, not the most technical of checks but i'm sure that's a reliable DIY way of checking?
 Back to top
View user's profile Send private message You must be logged in to rate posts

wots
World Chat Champion



Joined: 30 Aug 2012
Karma :

PostPosted: 08:19 - 28 Feb 2014    Post subject: Reply with quote

Coil packs, prone to rusting. Other Kwaks use the same one (can't remember which) so don't pay ER6 premium prices.

Careful when you are taking them out, as if they've started to crumble the metal band around it can split and make it more difficult to pull them out. Suggest rag and something to grip the top with, then twist/pull.

When my exhaust went, it lost a lot of power. In fact I think it's leaking again (botched repair) as it's been running a little rough just recently. However, not bad after a year and I managed to cleanly remove all studs the other day, so I'm exchanging the manifold.
____________________
Currently: Yamaha DT 125 LC2,Repsol Fireblade, and Bumblebee MSX 125
 Back to top
View user's profile Send private message You must be logged in to rate posts

Darylw27
Nova Slayer



Joined: 19 May 2011
Karma :

PostPosted: 14:39 - 28 Feb 2014    Post subject: Reply with quote

Had a friend round who's on his last year of his apprenticeship with bikes, double checked the exhaust confirmed its not blowing. Had a look at the coils, one of the left popped out with a bit of twisting and pulling. One on the right however is seized, almost completely, I have acquired two spare coils from a mate to replace it with. Problem now is the fact I'm unable to get the right one off... popped a rag over it and used vice grip pliers and the plastic is tearing off before the coil even budges. Totally lost at how I can remove this, used about half a can of WD40 in the hopes it would find its way down to no avail. Any ideas now? Seems likely the coil has packed it in given how corroded it must be.
 Back to top
View user's profile Send private message You must be logged in to rate posts

wots
World Chat Champion



Joined: 30 Aug 2012
Karma :

PostPosted: 14:42 - 28 Feb 2014    Post subject: Reply with quote

Same problem with mine, although mine hadn't actually gone, it wouldn't have been long. They were wedged in hard.

I just put a rag on and used some pipe grips, and made sure I was grabbing as much of the thing as possible. Twisting is more important than pulling until it starts to move.

Be very careful though.
____________________
Currently: Yamaha DT 125 LC2,Repsol Fireblade, and Bumblebee MSX 125
 Back to top
View user's profile Send private message You must be logged in to rate posts
Vincent This post is not being displayed because the poster is banned. Unhide this post / all posts.

stinkwheel
Bovine Proctologist



Joined: 12 Jul 2004
Karma :

PostPosted: 18:01 - 28 Feb 2014    Post subject: Reply with quote

Vincent wrote:

Are you sure you're not talking about exhaust baffles? Coils are electronic components usually attached to the frame under the fuel tank Wink


They have those dumbass plug-cap mounted ignition coils and appear to have carried over the design flaw from the EX500 engines where they have a very deep plug recess drained by a tiny little hole which can fill up with water and corrode the shit out of everything.

@ Darylw27 It might be simpler to drain down the coolant and remove the entire rocker cover then tackle them on a bench from both sides.
____________________
“Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles.
 Back to top
View user's profile Send private message You must be logged in to rate posts
Vincent This post is not being displayed because the poster is banned. Unhide this post / all posts.

Darylw27
Nova Slayer



Joined: 19 May 2011
Karma :

PostPosted: 21:45 - 04 Mar 2014    Post subject: Reply with quote

Just a little update, turns out it was indeed the coil. The rubber had split and the whole thing was a corroded mess, so much so I had to take it to a friends bike garage to remove it for me since the whole plastic snapped off the plug part in my efforts to twist it.

Thanks for the help and suggestions everyone! Thumbs Up
 Back to top
View user's profile Send private message You must be logged in to rate posts
Old Thread Alert!

The last post was made 12 years, 260 days ago. Instead of replying here, would creating a new thread be more useful?
  Display posts from previous:   
This page may contain affiliate links, which means we may earn a small commission if a visitor clicks through and makes a purchase. By clicking on an affiliate link, you accept that third-party cookies will be set.

Post new topic   Reply to topic    Bike Chat Forums Index -> The Workshop All times are GMT
Page 1 of 1

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

Read the Terms of Use! - Powered by phpBB © phpBB Group
 

Debug Mode: ON - Server: biskey (www) - Page Generation Time: 0.06 Sec - Server Load: 0.64 - MySQL Queries: 16 - Page Size: 82.16 Kb