|
|
| Author |
Message |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 16:46 - 22 Apr 2014 Post subject: GPZ 500 oil leak hah |
 |
|
Riding home from work today I get to about 2 miles from home and some dimwits try to cut me off from merging by driving bumper to bumper, so I let rip and race ahead when I get chance (naughty, I know). Not long after I start to notice a smell that isn't normal.... actually, I don't remember at what point I noticed the smell... err... anyway I pull up outside my garage to see steam/smoke from RHS of the engine. Looks like oil is seeping from my clutch cover, dripping down onto the frame and eventually hitting the floor. I can only assume the gasket is gone... I don't have the time or heat-resistant skin to investigate further just yet.
Did my aggressive riding blow it? IIRC it has about 25k miles on the clock, should I expect it to go anyway for wear & tear? I've not had this bike long, and also I'm still a bit thick  ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| stinkwheel |
This post is not being displayed .
|
 stinkwheel Bovine Proctologist

Joined: 12 Jul 2004 Karma :    
|
 Posted: 16:55 - 22 Apr 2014 Post subject: |
 |
|
Sometimes the mechanical seal behind the water pump lets go.
FIrst find where the oil is coming from. It's not always coming from where the most oil is. Cleaning the engine thoroughly will help. I've even scattered a small amount of cemet dust over the outside of an engine before to isolate an oil leak.
For example, if you're seeing oil on the clutch cover, it could easily be coming from a perforated oil filter and blowing back along the engine then trickling down the outside of the clutch cover. ____________________ “Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles. |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 17:03 - 22 Apr 2014 Post subject: |
 |
|
Yeah, I figured. From what I could quick glance, the oil appears to be seeping from the joint between the engine and clutch cover on the bottom edge. More investigation later. ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TheManWithThe... |
This post is not being displayed .
|
 TheManWithThe... Brolly Dolly

Joined: 30 Aug 2010 Karma :  
|
 Posted: 17:07 - 22 Apr 2014 Post subject: |
 |
|
is it similar looking to the oil leak in this thread?
https://www.bikechatforums.com/viewtopic.php?t=288563
I had a rhs oil leak on my er5 and assumed it was a bad clutch gasket, but a rebuild (not because of the leak) proved it wasn't, so now thinking it's the seal behind the water pump, as suggested above. ____________________ MBK Nitro 50, Sold. Kawasaki ER-5, Honda ST1100
"Anyone can jump a motorcycle! The trouble begins when you try to land it..." |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TUG |
This post is not being displayed .
|
 TUG World Chat Champion
Joined: 12 May 2007 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| stinkwheel |
This post is not being displayed .
|
 stinkwheel Bovine Proctologist

Joined: 12 Jul 2004 Karma :    
|
 Posted: 08:51 - 23 Apr 2014 Post subject: |
 |
|
The clutch is not pressurised (or it shouldn't be) so a leaky clutch cover gasket ought to leak all the time, not just when the engine is running (unless it is a very small leak which only happens when the oil is hot and runny).
So if it is leaking from there only when the engine is running it means the crankcase has become pressurised and therefore the crankcase breather is blocked. There is (obviously) a pressurised oilway behind the pressure guage blanking screw. Just a fiber gasket as I recall.
Anyway, an oil leak only when the engine is running pretty much has to be coming from a pressurised part of the engine. It shouldn't be from either if the side cover gaskets unless the breather is blocked.
Do have a good look at the oil filter. They can be hit by stones or rust through very easily and they are part of the pressurised oil circulation system. From experience, you can have a pinhole in your oil filter that mists oil out only at high revs. That oil can land up anywhere. In my case it was on my right foot and the mainstand. ____________________ “Rule one: Always stick around for one more drink. That's when things happen. That's when you find out everything you want to know.”
I did the 2010 Round Britain Rally on my 350 Bullet. 89 landmarks, 3 months, 9,500 miles. |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| lihp |
This post is not being displayed .
|
 lihp World Chat Champion
Joined: 22 Sep 2010 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| lihp |
This post is not being displayed .
|
 lihp World Chat Champion
Joined: 22 Sep 2010 Karma :   
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TUG |
This post is not being displayed .
|
 TUG World Chat Champion
Joined: 12 May 2007 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 21:02 - 23 Apr 2014 Post subject: |
 |
|
Wise ones, it turns out it is the water pump. If the seals are so damaged that water is making it to the outside of the bike, should I be doubting the bearing in the pump? I just ask for peoples' past experiences, as I don't have the privilege of being able to leave a job and come back to it. Having the garage 100yds from the house I try to start and finish a job in one go. Fffffff....  ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TUG |
This post is not being displayed .
|
 TUG World Chat Champion
Joined: 12 May 2007 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 08:59 - 24 Apr 2014 Post subject: |
 |
|
Have done now. On Nokia Potato HD. Hope the upload worked. ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TUG |
This post is not being displayed .
|
 TUG World Chat Champion
Joined: 12 May 2007 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 09:19 - 24 Apr 2014 Post subject: |
 |
|
Yarp. Just read through your post while work is quiet. I see the difference.
If I'm changing both seals, the mechanical and the oil, I'll need to drain the oil off won't I? Or should the angle on the sidestand give me enough clearance as it were? ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| TUG |
This post is not being displayed .
|
 TUG World Chat Champion
Joined: 12 May 2007 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
 Posted: 09:47 - 24 Apr 2014 Post subject: |
 |
|
True. Oil filters getting tatty anyways so it'll be due. Thanks folks for all feedback. Hope you get/got sorted Tug  ____________________ My deviantArt gallery - My Youtube profile
Honda CG125 -> Baotian BT49 -> AJS JS125 -> Honda CG125-> Kawasaki ZL400 -> Kawasaki GPZ500 |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| stinkwheel |
This post is not being displayed .
|
 stinkwheel Bovine Proctologist

Joined: 12 Jul 2004 Karma :    
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Mez |
This post is not being displayed .
|
 Mez Trackday Trickster

Joined: 13 Mar 2004 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 207 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|