xj 600s Gear problem

rob_rob999 · Renault 5 Driver Joined: 06 Nov 2011 Karma :

Hi All

I have a xj 600s L reg 1993 and just recently it is very hard to get into gear sometimes I have to let the clutch out a bit and it will go into gear then but I have trouble shifting up and down.

I know they suffer with clutch rattle which mine has

I have also noticed when on its stand and I put it into gear and let the clutch out it is ok but when I pull it in the back wheel stops as though the back brake has been applied
Also there is a squealing noise when I operate the clutch coming from the clutch side of the bike could it be the clutch plates are worn ????

Or something more serious

HELP
Thanks Rob

rob_rob999 · Renault 5 Driver Joined: 06 Nov 2011 Karma :

Anyone help please

Hahadumball · World Chat Champion Joined: 07 Oct 2015 Karma :

it stops the drive to the rear wheel when you pull the clutch in?

thats deffo not right
Rolling Eyes

____________________
Fin: no matter how much I look at It I can't understand what was going through my head, all I remember is going about 80 and redlining it to stop it seizing.
360 Deg... Five 1/4 turns. :- Teflon-Mike 18 Jan 2015

Stalk · Brolly Dolly Joined: 26 Dec 2005 Karma :

https://diversionclub.proboards.com
You need this site
Good luck
Cheers

davebike · World Chat Champion Joined: 15 Nov 2013 Karma :

Simple bits

Adjust clutch cable
Is oil clean and at the upper level mark?
Is the gear leaver and linkage moving freely?

Has the bike been standing unused fro more than a week ?
____________________
Dave
NC750Xdct + others at work !
davebike1@gmail.com

A100man · World Chat Champion Joined: 19 Aug 2013 Karma :

If it stops abruptly (on the stand) when the clutch is pulled in then it sounds like one of your problems is a binding rear brake.
____________________
Now: A100, GT250A, XJ598, FZ750

Then: Fizz, RS200, KL250, XJ550, Laverda Alpina, XJ600, FZS600

Vincent · Banned Joined: 16 Oct 2006 Karma :

Try selecting the gears by hand without the engine running. You'll need to get the back wheel off the ground and move it backwards and forwards. To recap - left hand on gear lever, right hand moving the back wheel forwards and backwards. If the selectors are OK, you should be able to get through the gears without too much difficulty and, if you can, it's the clutch at fault.

As above, you need to work out why the back wheel is sticking though. Most likely it's the brake binding and the calliper needs cleaning up/freeing off but it can also be a damaged wheel bearing or incorrectly assembled rear axle assy.
____________________
Space Is Deep