honda cg 125 clutch

[stuartt]

i bought a cg 125 for my boy yesterday .

the clutch won't disengage when you pull the clutch in .

i've stripped it down a few times & it looks ok as far as i can tell .

what i'm not sure about is the shaft that comes out of the engine has a outer & inner bit , should the inner shaft move in to the outer shaft to allow the the clutch to disengage ?

advice needed please .

[Ariel Badger]

Can you see the plates opening when you pull the lever in?
____________________
Bikers make great organ donors, get 115 on your licence today.

[stuartt]

when i put the cover back on i can't see a thing , the lever feels ok but nothing happens .

i should add the bike is a 2008 with 1900 mls & has lay in a garden since 2009 when the 1st yrs tax ran out !

[lukamon]

hmmm... maybe the clutch is stuck?

if you havnt been messing with the adjusters and have assembled it back right, then that might be it. push it in nutral, run along side as fast as you can, jump on, pull in clutch, bang into second

that's what id do anyway. it might take a few tries
____________________
killa wrote: Im an ass man myself

[stuartt]

what are the adjusters ?

when the clutch is off the inner & outer shaft turn separately , i think the inner shaft should go in to the outer shaft when the clutch lever is pulled to disengage the clutch , is that what should happen ?

[lukamon]

the screws / nuts that adjust the length of the clutch cable?

anyway, go give it a try. you never know
____________________
killa wrote: Im an ass man myself

[stuartt]

i'll put it back together & try thanks

[lukamon]

oh wait... its apart now? why not post a pic of it
____________________
killa wrote: Im an ass man myself

[stuartt]

can't post pics , it stresses me to fk trying to post pics

[Alpha-9]

[stuartt]

https://postimg.org/image/6sjs7gmsh/

[stuartt]

https://s23.postimg.org/w9cesdiwr/IMAG0069.jpg

[stuartt]

here's a link to a pic someone else posted .

in the middle of the clutch theres a pin going in to the shaft . my clutch seems to be missing the pin , i take it thats my problem ?

https://www.flickr.com/photos/grillyfish/8153404609/

[mudcow007]

Yap

that pin is what gets pushed, to push the plates together

cmsnl or ebay will be your friend here

or speak to Honda

[stuartt]

ok , thanks

[mudcow007]

[stuartt]

thanks , all the bits for the wee bike seem to be cheap