|
|
| Author |
Message |
| merky69 |
This post is not being displayed .
|
 merky69 Borekit Bruiser
Joined: 02 May 2013 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| Kickstart |
This post is not being displayed .
|
 Kickstart The Oracle

Joined: 04 Feb 2002 Karma :     
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| MattWadz |
This post is not being displayed .
|
 MattWadz Trackday Trickster

Joined: 08 Apr 2011 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| - |
This post is not being displayed because the poster has bad karma. Unhide this post / all posts.
|
 - Super Spammer
Joined: 22 Oct 2013 Karma :     
|
 Posted: 13:39 - 05 Mar 2014 Post subject: |
 |
|
I put a throttle slide back in a DT175 the wrong way as a teenager. It'll rev a lot higher than 6.7K if you did, trust me
It revved that high that I couldn't stop it. Cutting the ignition and pulling the HT lead didn't help, it seized before the float bowl ran out of fuel.
I reckon a stuck or badly routed throttle cable, or maybe something else holding the slide open too much. Take the airbox off and look at the mouth of the carb. The slide should only be open about 3 or 4 mm from the bottom of the carb. If it's higher, check the stop screw on the carb isn't wound right in.
Last edited by - on 14:10 - 05 Mar 2014; edited 1 time in total |
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
| P.addy |
This post is not being displayed .
|
 P.addy Red Rocket
Joined: 14 Feb 2008 Karma :  
|
|
| Back to top |
|
You must be logged in to rate posts |
|
 |
Old Thread Alert!
The last post was made 12 years, 260 days ago. Instead of replying here, would creating a new thread be more useful? |
 |
|
|